See what's new at PRINTING UnitedNew at PRINTING UnitedBooth 3268 · Las Vegas · Sept 23–25Book a demo
ContactShop — dealer and account ordering

Prestige L2 & XL2

Prestige L2 & XL2 - Prestige Large Format Printers - How to Adjust the Tension Bar Bracket

Every step links to its own moment in the video, so you never hunt for the right part again.

  • 5 steps
  • 21 instructions
  • 1 video
  • Updated 2026-04-20

Prestige L2 User manualPrestige XL2 Installation & setup guideThe full manual, beyond first setup. · All manuals

Tension Bar Bracket Installation for Prestige L2–XL4 DTF Printers

  1. 0:00Procedure Overview and Scope
  2. 1:02Removing Media Holders and Tension Bar
  3. 4:14Reinstalling the Tension Bar Bracket
Written steps5

Procedure Overview and Scope

Watch this part0:00
  1. Confirm the printer model is a large format Prestige DTF printer, including models L2 through XL4.
  2. Understand this procedure ensures correct installation of the tension bar holder bracket to prevent premature wear of the media tension sensor.

Initial Preparation

  1. Power on the printer.
  2. Remove the film from the printer bed.

Removing Media Holders and Tension Bar

Watch this part1:02
  1. Go to the back of the printer.
  2. Loosen the screws securing the media holders.
  3. Move the media holder to the right.
  4. Remove the media.
  5. Slide the right-side media holder to the left.
  6. Remove the screws securing the tension bar.
  7. Loosen the knob on the left media holder.
  8. Move the left media holder slightly to the right.
  9. Remove the screws from the left media holder.

Identifying Left and Right Media Holders

  1. Identify the left and right media holders before reinstallation.
  2. Verify the semicircular shaped tool is positioned on the top, not the bottom.
  3. Double-check orientation to ensure the correct holder is mounted on each side.

Reinstalling the Tension Bar Bracket

Watch this part4:14
  1. Place the brackets back onto the printer.
  2. Insert the tension bar into the bracket grooves.
  3. Verify the tension bar moves freely up and down.
  4. Adjust the bracket position as needed.
  5. Tighten the screws to secure the brackets in place.

Stuck on a step?

Our US tech team answers on Discord, and it is the fastest route to a person who knows this machine.

Get support