See what's new at PRINTING UnitedNew at PRINTING UnitedBooth 3268 · Las Vegas · Sept 23–25Book a demo
ContactShop — dealer and account ordering

Prestige L2 & XL2

Prestige L2 & XL2 - How to Replace Capping Station Pump

Every step links to its own moment in the video, so you never hunt for the right part again.

  • 6 steps
  • 27 instructions
  • 1 video
  • Updated 2026-04-20

Prestige L2 User manualPrestige XL2 Installation & setup guideThe full manual, beyond first setup. · All manuals

How to Replace the Capping Station Pump

  1. 0:05Overview
  2. 0:12Step 1 – Access the Capping Station
  3. 0:33Step 2 – Disconnect the Pump Cable
  4. 0:52Step 3 – Remove the Old Pump
  5. 1:30Step 4 – Install the New Pump
  6. 2:45Step 5 – Reassemble and Test
Written steps6

Overview

Watch this part0:05

DESCRIPTION This guide walks through replacing the capping station pump and verifying proper installation.

Step 1 – Access the Capping Station

Watch this part0:12
  1. Open the printer cover.
  2. Release the printer carriage.
  3. Move the carriage away from the capping station to create working space.
  4. Using a screwdriver, remove the five screws securing the capping station cover.
  5. Remove the capping station cover.

Step 2 – Disconnect the Pump Cable

Watch this part0:33
  1. Locate the cable tie securing the pump cable.
  2. Use scissors to cut the cable tie.
  3. Identify the cable corresponding to the pump being replaced.
  4. Disconnect the pump cable.

Step 3 – Remove the Old Pump

Watch this part0:52
  1. Open the right-side door of the printer.
  2. Locate the pump that corresponds to the disconnected cable.
  3. Remove the two mounting screws holding the pump in place.
  4. Pull the pump out.
  5. Disconnect the ink tube by twisting to unlock.
  6. Pull the cable fully out of the printer.

Step 4 – Install the New Pump

Watch this part1:30
  1. Take the new pump.
  2. Connect the ink tubes to the pump.
  3. Twist to the right to fully tighten the tube connections.
  4. Feed the pump cable all the way through the printer.
  5. Insert the pump into its mounting slot.
  6. Secure the pump using the two mounting screws.
  7. Connect the pump cable.
  8. Use a zip tie to secure the cable neatly and keep it out of the way.

Step 5 – Reassemble and Test

Watch this part2:45
  1. Reinstall the capping station cover.
  2. Secure the cover using the five screws removed earlier.
  3. Turn the printer ON.
  4. Perform a head cleaning. VERIFICATION CHECK
  • If ink flows through the lines during cleaning:
  • The pump has been installed correctly.
  • If ink does not flow:
  • Recheck tube connections, cable connection, and pump seating.

Stuck on a step?

Our US tech team answers on Discord, and it is the fastest route to a person who knows this machine.

Get support