See what's new at PRINTING UnitedNew at PRINTING UnitedBooth 3268 · Las Vegas · Sept 23–25Book a demo
ContactShop — dealer and account ordering

Arc 127

Arc 127 - Maintenance Guide

Every step links to its own moment in the videos, so you never hunt for the right part again.

  • 4 steps
  • 25 instructions
  • 2 videos
  • 2 chapters
  • Updated 2026-02-17

User manualThe full manual, beyond first setup. · All manuals

Daily Maintenance

Arc 127 End-of-Day Maintenance

  1. 0:00Power Down and Air Release
  2. 0:32Clean Blade and Cutting Area
Written steps2

Power Down and Air Release

Watch this part0:00
  1. Turn off the main power switch on the machine.
  2. Unplug the main power cord.
  3. Turn off the air compressor by pressing down its main power switch.
  4. Close the air outlet valve on the compressor.
  5. Unplug the compressor power cord.
  6. Pull the connector switch backward.
  7. Remove the air tube to release air inside the machine and prevent water buildup and potential damage.

Clean Blade and Cutting Area

Watch this part0:32
  1. Loosen the screw holding the blade holder.
  2. Remove any scraps or debris around the blade and blade holder.
  3. Clean the blade and blade holder using alcohol.
  4. Vacuum the cutting platform to remove debris.
  5. Dispose of waste film from the collector basket.
  6. Cover the cutter to protect it from dust and debris.

Weekly Maintenance

Arc 127 Weekly Maintenance

  1. 0:00Drain Oil Water Filter
  2. 0:47Drain Air Compressor
Written steps2

Drain Oil Water Filter

Watch this part0:00
  1. Go to the take-up reel side of the machine.
  2. Remove the machine cover to expose the internal components.
  3. Locate the oil water filter on the right side of the machine.
  4. Inspect the clear cylinder under the filter for water buildup.
  5. Pull the drain ring downward using a paper towel to remove excess water.
  6. Confirm the water has been fully drained.
  7. Perform this procedure weekly.

Drain Air Compressor

Watch this part0:47
  1. Locate the air compressor underneath the machine.
  2. Find the air receiver drain plug on the compressor.
  3. Unscrew the drain plug to release any water buildup.
  4. Allow all water to drain completely.
  5. Tighten the drain plug back into position once draining is complete.

Stuck on a step?

Our US tech team answers on Discord, and it is the fastest route to a person who knows this machine.

Get support